Skip to Knowledge Base content

Blinking Projector Problem

Most of the time, projectors will start blinking if the blank button is pressed on the touch panel too many times in too rapid a fashion. The blank button takes a second to turn red because it does not turn red based upon user touch - it turns red based upon the projector sending back a confirmation to the system that the projector is successfully blanked. Often during this short (>1 second) delay, the button will be pressed a few times, resulting in the system blanking and un-blanking, and often times this leads to the button being pushed multiple times too quickly and the projector getting overloaded with commands, and it gets stuck in a loop, blinking on and off. The only way to stop it is to turn it off and back on again.

Details

Article ID: 25521
Created
Thu 2/23/17 11:37 AM
Modified
Fri 5/12/17 11:01 AM